Compare

You have no items to compare.

15" Replacement Hose Whip

Part #: 509

UPC: 30937300980

Number of items in this pack: 1

  • Replacement part
  • Used to replace hose whip on Milton inflator gauge #506
  • 1/8" -27 threads NPT
  • 10 to 160 pounds per square inch
List:
$24.40
This 15 inch heavy duty hose whip can be used to replace the old hose on the original dual head inflator gauge #506.

INSTRUCTIONS FOR USE:

If using a dual head type tire chuck with an inflator gauge and notice air is escaping through the off-side once connected to the tire’s Schrader valve, simply release the trigger and remove the inflator from the Schrader/tire valve. Point the straight side of the outlet up into the air (make sure it’s not pointed at someone). Squeeze trigger, allow air to flow (gravity will cause the sealing valve to drop), and place the chuck end onto the Schrader/tire valve while air is still flowing. Air will start to flow into the tire.

Dual head type tire chucks are unable to inflate a completely flat (zero air pressure) tire. Tire air pressure would normally cause the sealing valve to move and seal the unused side of the chuck. However, if a tire has 0 air pressure, the self-sealing valve has no pressure to react to.

Weight 0.5000
Made in USA Yes
Gauge Type Replacment Hose Whip
Hose length 15" Hose
Manufacturer Milton Industries
Height 0.62
Width 1.12
Length 22
Usage Used on #506

Product Questions

No Questions

Warning

CANCER AND REPRODUCTIVE HARM www.P65Warnings.ca.gov